INTERSTATE AND INTERNATIONAL AQUIFERS1

Many important groundwater aquifers cross state and national boundaries. The flow of water in these aquifers is not influenced by the boundaries but may be materially influenced by mans activities on one or both sides of a boundary. Interstate and international problems may develop because of excessive groundwater lowering on one side of a boundary affecting water users on the opposite side of the line. Similarly, intensive groundwater development along a surface stream may influence the amount of surface water that flows across a boundary. A third type of problem may develop when pumping on one side of the boundary induces poor quality water into an aquifer on the other side of the boundary. Several specific interstate and international aquifer problems are briefly described.     

Modeling methyl isothiocyanate soil flux and emission ratio from a field following a chemigation of metam-sodium

Metam-sodium had become the most heavily used soil fumigant in recent years as the deadline approached for methyl bromide to phase out in January 2005. After application, metam-sodium decomposes rapidly to methyl isothiocyanate (MITC), a highly toxic compound capable of killing a wide spectrum of soil-borne pests. Inhalation risk of MITC ranked high among airborne agricultural pesticides in California. Information about off-gassing intensity and percentage of emission is essential for exposure risk assessment and mitigation measures, but is limited, especially for new application methods such as drip chemigation. Air concentrations of MITC were monitored around a field treated with metam-sodium through surface drip irrigation system. The field was tarped with plastic films before the chemigation. The air concentrations at receptor locations were simulated for the period of air monitoring with the Industrial Source Complex (ISC3) Dispersion Model, and soil flux density of MITC at various periods after chemigation was estimated through a back-calculation procedure. The estimated soil flux density of MITC showed a diurnal pattern, with the daytime flux stronger than nighttime. However, the average air concentration at nighttime was higher than that at daytime. Soil flux density peaked at 4.30 microg m-2 s-1 in the first 12-h period after chemigation, then declined with time. The MITC emission percentage in the first 60-h was 2.65% of applied mass, of which 57% occurred in the first 24-h after chemigation. The study indicated that the tarped bed drip application method of metam-sodium had a relatively good control of MITC emission from soil.     

Trace metals in the hair of habitants of the Ok Tedi region, Papua New Guinea

It has long been known that mining activity can markedly change the level and distribution of certain heavy metals in the adjacent environment. This pollution can be quite widespread and long lasting and often has deleterious effects on the health of local populations. In the present study scalp hair was used as the biopsy material because of its ease of collection and long history of use in this connection. Hair was collected from all the local villages in the vicinity of the mine site, as well as from Papua New Guinean nationals from other provinces, and European expatriates who were employed by the mining company and who were resident in the area. Hair from local people showed a remarkably high iron content by comparison with previously studied populations. The extreme variations in hair iron levels were reflected in the differential distribution of levels according to location, age and sex. Hair cadmium was also high in the population studied. Hair copper, lead, zinc and mercury all appeared to be within 'normal' limits by comparison with other general populations. These results are discussed in the context of the environmental and social impact of the mining operations on the local people.     

CSHM: Web-based safety and health monitoring system for construction management

INTRODUCTION: This paper describes a web-based system for monitoring and assessing construction safety and health performance, entitled the Construction Safety and Health Monitoring (CSHM) system. METHOD: The design and development of CSHM is an integration of internet and database systems, with the intent to create a total automated safety and health management tool. A list of safety and health performance parameters was devised for the management of safety and health in construction. A conceptual framework of the four key components of CSHM is presented: (a) Web-based Interface (templates); (b) Knowledge Base; (c) Output Data; and (d) Benchmark Group. RESULTS: The combined effect of these components results in a system that enables speedy performance assessment of safety and health activities on construction sites. With the CSHM's built-in functions, important management decisions can theoretically be made and corrective actions can be taken before potential hazards turn into fatal or injurious occupational accidents. IMPACT ON INDUSTRY: As such, the CSHM system will accelerate the monitoring and assessing of performance safety and health management tasks.     

The localized environmental degradation of protected areas adjacent to bird feeding stations: a case study of the Australian brush-turkey Alectura lathami

This study investigated the potential for wildlife feeding to artificially increase population densities of the Australian brush-turkey, Alectura lathami and assessed the indirect adverse effects that this may have on surrounding forest floor vegetation. Census counts and observations of feeding activity conducted in recreation areas of Australia's Gold Coast hinterland confirmed that brush-turkey population densities were significantly elevated by the provision of food by humans. Brush-turkey densities were high at sites where birds are actively fed, moderate at sites where birds feed opportunistically and low at sites where humans have negligible impact on local food availability. Brush-turkeys caused significant environmental impact at sites where their population densities have been substantially elevated by active feeding. Across all sites, increases in brush-turkey density were accompanied by a significant decline in ground cover, leaf litter weight, seed density and seedling density. Natural environmental variables such as gradient, vegetation type and canopy cover did not explain the observed impacts. The impacts were consistent with those described in trampling studies and suggest that at high density, even small animals can have significant trampling impacts on their local environment. This study demonstrates that wildlife feeding can have detrimental impacts on the integrity of local environments and recommends greater consideration of small animals and their potential indirect impacts when regulating wildlife feeding in National Parks and other nature conservation areas.     

Current issues and uncertainties in the measurement and modelling of air-vegetation exchange and within-plant processing of POPs

Air-vegetation exchange of POPs is an important process controlling the entry of POPs into terrestrial food chains, and may also have a significant effect on the global movement of these compounds. Many factors affect the air-vegetation transfer including: the physicochemical properties of the compounds of interest; environmental factors such as temperature, wind speed, humidity and light conditions; and plant characteristics such as functional type, leaf surface area, cuticular structure, and leaf longevity. The purpose of this review is to quantify the effects these differences might have on air/plant exchange of POPs, and to point out the major gaps in the knowledge of this subject that require further research. Uptake mechanisms are complicated, with the role of each factor in controlling partitioning, fate and behaviour process still not fully understood. Consequently, current models of air-vegetation exchange do not incorporate variability in these factors, with the exception of temperature. These models instead rely on using average values for a number of environmental factors (e.g. plant lipid content, surface area), ignoring the large variations in these values. The available models suggest that boundary layer conductance is of key importance in the uptake of POPs, although large uncertainties in the cuticular pathway prevents confirmation of this with any degree of certainty, and experimental data seems to show plant-side resistance to be important. Models are usually based on the assumption that POP uptake occurs through the lipophilic cuticle which covers aerial surfaces of plants. However, some authors have recently attached greater importance to the stomatal route of entry into the leaf for gas phase compounds. There is a need for greater mechanistic understanding of air-plant exchange and the 'scaling' of factors affecting it. The review also suggests a number of key variables that researchers should measure in their experiments to allow comparisons to be made between studies in order to improve our understanding of what causes any differences in measured data between sites.     

Resolving Chernobyl vs. global fallout contributions in soils from Poland using Plutonium atom ratios measured by inductively coupled plasma mass spectrometry

Plutonium in Polish forest soils and the Bór za Lasem peat bog is resolved between Chernobyl and global fallout contributions via inductively coupled plasma mass spectrometric measurements of 240Pu/230Pu and 241Pu/239Pu atom ratios in previously prepared NdF3 alpha spectrometric sources. Compared to global fallout, Chernobyl Pu exhibits higher abundances of 240Pu and 241Pu. The ratios 240Pu/230Pu and 241Pu/239Pu co-vary and range from 0.186 to 0.348 and 0.0029 to 0.0412, respectively, in forest soils (241Pu/239Pu = 0.2407 x [240Pu/239Pu] - 0.0413; r2 = 0.9924). Two-component mixing models are developed to apportion 239+240Pu and 241Pu activities; various estimates of the percentage of Chernobyl-derived 239+240Pu activity in forest soils range from < 10% to > 90% for the sample set. The 240Pu/230Pu - 241Pu/239Pu atom ratio mixing line extrapolates to estimate 241Pu/239Pu and the 241Pu/239+240Pu activity ratio for the Chernobyl source term (0.123 +/- 0.0007; 83 +/- 5; 1 May 1986). Sample 241Pu activities, calculated using existing alpha spectrometric 239+240Pu activities, and the 240Pu/230Pu and 241Pu/239Pu atom ratios, agree relatively well with previous liquid scintillation spectrometry measurements. Chernobyl Pu is most evident in locations from northeastern Poland. The 241Pu activities and/or the 241Pu/239Pu atom ratios are more sensitive than 240Pu/239Pu or 238Pu/239+240Pu activity ratios at detecting small Chernobyl 239+240Pu inputs, found in southern Poland. The mass spectrometric data show that the 241Pu activity is 40-62% Chernobyl-derived in southern Poland, and 58-96% Chernobyl in northeastern Poland. The Bór za Lasem peat bog (49.42 degrees N, 19.75 degrees E), located in the Orawsko-Nowotarska valley of southern Poland, consists of global fallout Pu.     

Phosphorus in waters from sewage sludge amended lysimeters

In surface waters, phosphorus (P) concentrations exceeding 0.05 mg liter(-1) may cause eutrophic conditions. This study was undertaken to measure total P concentrations in runoff and tile drainage waters from land receiving either inorganic fertilizer or anaerobically digested sewage sludge. Total P was measured in runoff and tile drainage waters during 2 years of sample collections from instrumented, large-scale lysimeters planted to corn (Zea mays L.). During the 3 years prior to monitoring P concentrations, six of the lysimeter plots had been amended with anaerobically digested sewage sludge which supplied 5033 kg P per ha. Additional sludge applications supplied 1058 and 1989 kg P per ha during the first and second years of monitoring operations, respectively. Another six lysimeters were annually treated with fertilizer which included P applications amounting to 112 kg ha(-1). For years 1 and 2, respectively, annual losses from lysimeters treated with sewage sludge were 4.27 and 0.35 kg P per ha in runoff and 0.91 from 0.91 and 0.51 kg Per P per ha in drainage waters. Parallel annual losses of P from lysimeters treated with superphosphate were 2.15 and 0.17 kg ha(-1) in runoff and 0.53 and 0.35 kg ha(-1) in tile drainage waters. Sludge applications did not significantly change absolute soil contents of organic P, but did decrease the per cent of total P present in organic forms. Sludge and soil, respectively, contained 21 and 36% of their total P contents in organic forms. In sludge and soil about 85 and 64% of their respective total inorganic P contents were associated with the Al and Fe fractions. Sludge applications significantly increased soil contents of P in the saloid (water-soluble plus P extracted with 1 N NH(4)Cl), Al, Fe and reductant soluble P fractions, but contents of Ca-bound P were not changed. Total P contents of the soil below a depth of 30 cm were not affected by sludge incorporated to a depth of about 15 cm by plowing.     

Evaluating factors influencing groundwater vulnerability to nitrate pollution: developing the potential of GIS

The 1991 EU Nitrate Directive was designed to reduce water pollution from agriculturally derived nitrates. England and Wales implemented this Directive by controlling agricultural activities within their most vulnerable areas termed Nitrate Vulnerable Zones. These were designated by identifying drinking water catchments (surface and groundwater), at risk from nitrate pollution. However, this method contravened the Nitrate Directive because it only protected drinking water and not all waters. In this paper, a GIS was used to identify all areas of groundwater vulnerable to nitrate pollution. This was achieved by constructing a model containing data on four characteristics: the quality of the water leaving the root zone of a piece of land; soil information; presence of low permeability superficial (drift) material; and aquifer properties. These were combined in a GIS and the various combinations converted into a measure of vulnerability using expert knowledge. Several model variants were produced using different estimates of the quality of the water leaving the root zone and contrasting methods of weighting the input data. When the final models were assessed all produced similar spatial patterns and, when verified by comparison with trend data derived from monitored nitrate concentrations, all the models were statistically significant predictors of groundwater nitrate concentrations. The best predictive model contained a model of nitrate leaching but no land use information, implying that changes in land use will not affect designations based upon this model. The relationship between nitrate levels and borehole intake depths was investigated since there was concern that the observed contrasts in nitrate levels between vulnerability categories might be reflecting differences in borehole intake depths and not actual vulnerability. However, this was not found to be statistically important. Our preferred model provides the basis for developing a new set of groundwater Nitrate Vulnerable Zones that should help England and Wales to comply with the EU Nitrate Directive.